1, will be classified in accordance with the specifications of the size of the plate, punching holes before the panel, side panels, etc. must be selected surface, the plate must be light to hold light to put

　　2, to the width of the largest number of plate size custom sub;; and

　　3, the first use of flat drilling and vertical drilling to play all the big flat buckle, the same system after playing the hole, such as the need to move the system, after adjusting the position of the hole operation as above.

　　4, to the width of the drawer side panels for the size of the benchmark, left and right custom sub; two side panels of thick skin together and placed in the middle of the position of the holes, drawer panels, left and right system are increased by 10mm and then placed on the platform to play holes.

　　5, after punching holes in all the panels to the trolley, do not fall, and then in accordance with the size of the panels categorised and stacked together.

　　6, switch off the row drill power supply, the machine on the saw foam blow clean.

　　7, each time you mobilise the brake or replace the drill or switch the drill bit button, the machine should be self-checked, when the machine appears abnormal, you should immediately press the emergency stop button and turn off the machine in time.

　　Things you should pay attention to in the use of woodworking row drills from row drill manufacturers:

　　The use of woodworking row drill need to pay attention to a lot of problems, including the correct use is important, and we use the woodworking row drill is also related to the safety issue, so that our row drill for the use of the drill bit must be careful. We also need to reasonably protect the drill bit, because the drill bit is very important for the row drill. The use of woodworking row drill also pay attention to prevent vibration collision. If the vibration of the row drill is too strong, then it has a great impact on the control of the processing accuracy of the row drill. This is very easy to produce unqualified waste products. So we usually use the row drill to save every part, and we avoid damaging parts to produce some unnecessary machine damage. The use of woodworking row drill for parts processing, we should be for some of the precision requirements of very high parts for microscope processing, which can greatly reduce the woodworking row drill error. Our woodworking drill needs to be installed with a certain degree of positioning accuracy. And in this kind of situation our precision adjustment should be adjusted according to their own product needs to adjust and requirements.

　　The correct use of row drill manufacturers woodworking row drill

　　1、Please read the manual in detail before operating this machine. Check whether the grounding wire is firmly grounded and whether the parts are normal. Whether the operation position is brightly lit, (untrained personnel should not operate this machine).

　　2、Operation should be three tight, three not, a note. Three tight: tight clothing, tight waist, tight sleeves; three not: no tie, no hand jewelry, no gloves; a note: pay attention to the protection of eyes.

　　3, before starting the machine, please pay attention to the instructions of all warning signs.

　　4、Find out the direction of rotation of the drill, the correct choice of drill.

　　5、Do not approach or touch the moving or rotating parts.

　　6、If the horizontal drilling interferes with the vertical drilling, asynchronous work must be selected.

　　7、Do not adjust or repair the machine until the main power is switched off.